Comments on: Mercedes Benz Fault Codes

By: Chris Horn

Chris Horn — Thu, 08 Feb 2018 14:39:15 +0000

i drove a 2013 Mercedes 250 cdi and it gave me a P2279 code on the scanner. it said it is a intake air system leak. i cannot find any info on that code and where is this sensor location

thanks.

By: Will

Will — Thu, 19 Oct 2017 00:16:54 +0000

My code is u10101.

By: Harry brown

Harry brown — Sat, 14 Oct 2017 15:00:41 +0000

2016 Sprinter 3500, dash flashes 6600

By: Earl Levels

Earl Levels — Tue, 19 Sep 2017 02:20:44 +0000

I have a code of 0845 in my history on my 05 Mercedes Benz ML350 computer.

By: Anthony

Anthony — Wed, 16 Aug 2017 19:34:24 +0000

I have a code that reads P20D5 The torque request from control module N15/3 (ETC control module) is
implausible. (P0702) can’t seem to figure what the problem stems from?? I have a Mercedes C320 2001 registration. Any ideas??

By: Mercedes Medic

Mercedes Medic — Tue, 15 Aug 2017 15:09:38 +0000

In reply to Stephen marx. We have an article on Adblue DEF now. Hope it helps.

By: Alonzo Braziel

Alonzo Braziel — Sun, 30 Jul 2017 19:35:02 +0000

In reply to Alonzo Braziel. Also on the 00 CL500 none of the windows or seats worked until the ignition set swap. Now the passenger front window and seat only operates. The driver's side window and seat doesn't work nor do the rear windows.

By: Alonzo Braziel

Alonzo Braziel — Sun, 30 Jul 2017 19:32:06 +0000

Hi. I’m wondering if you may be able to assist in tracking down a no start issue with a 00 CL500. I purchased the vehicle with the trans conductor issue which i haven’t fixed yet. I haven’t fixed the conductor issue because the smart key would not turn most of the time, the times it would turn I’d get a start maybe one out of 3 attempts then the car would run and drive for maybe 5 minutes before the trans went into limp mode. So first, i replaced the ignition set (smartkey, EIS, ECU and shifter ESL) all from the same car (an 01 s500). Now the key turns, the shifter unlocks, but the car doesn’t crank. I have a scanner that reads like the mb star and i have start authorization from the EIS and Shifter ESL but I’m getting a P1570 (No start enable sent from DAS) & P1605 from the ECU… If i disconnect the battery, for 30 seconds and reconnect, I can then turn the key and the starter cranks for maybe 2 seconds and stops and won’t crank again till i disconnect the battery for 30 seconds and reconnect and crank again for maybe 2 seconds and then no crank. Is there something wrong with the ignition set maybe? Also, the mileage displays for 2 seconds after opening the driver door then shows —— blank right after and won’t show mileage again till i reopen and close the driver door but it always only shows for 2 seconds. I’m stumped.