Comments on: E Class (1996-2002) W210 Fuse Box Chart Location Designation Diagram

By: Bobby wilson

Bobby wilson — Wed, 27 Dec 2017 21:12:47 +0000

The relay which controls the glow plugs stay on when plug is in relay and continue to stay on all the time even when engine is running causing check engine electric problems. If I disconnect the glow plug cable the relay does time out and the glow plugs relay turns off. It seems to work properly but if i plug the cable into the relay box the relay malfunction. Is the relay bad or the electronics computer defective.
My mercedes-benz is a 1998 e300 td

By: Neol

Neol — Sat, 02 Dec 2017 17:42:58 +0000

I have a 2001 E320
My radio and A/C information box does not work. Is there a fuse or relay that I need to replace.
My a/c only works on low

By: graham gingell

graham gingell — Thu, 16 Nov 2017 04:20:58 +0000

looking for starter fuse and relay to check if blown or damaged. why starter often fails to engage or crank longer than 1/10 second. yesterday it cold cranked 1/10 sec, 2nd try cranked 2/10sec, 3rd try it started.
i am used to car not starting but always starts by moving autobox gear selctor between park and drive, left and right or do a gearbox reset.
my 2002 e270 w210 cdi has 4 positions for fuses and relays, 3 as mentioned above plus 4th engine bay left side near heater duo valve. have multimetre will check all locations for blown fuses.
one of the rear number plate light fittings malfunctions, might need replacing-did the other side last month.
have fitted new mercedes brake switch, 1 new number plate lamp & new k140 or k40 relay??
problem persists.
think i am already on your mailing list!

By: JIMMY

JIMMY — Wed, 18 Oct 2017 03:01:35 +0000

VERY HELPFULL ILLUSTRATIONS .

By: ayad

ayad — Sat, 09 Sep 2017 20:01:00 +0000

A have Mercedes e-class Mo-1996 I like Mercedes its good car & top car in the world
Thank you MB Medic.

By: Chris Licari

Chris Licari — Wed, 09 Aug 2017 19:43:48 +0000

I am trying to find OBD 2 port fuse, on my 2000 Mercedes Benz E320, I was told there is one for OBD2 port? I have searched and not gotten a clear answer or reply, can someone assist me. Need clear directionsI bought new iCarSoft CE Plus scanner to pull my transmission out of limp mode (I had leak let it get to low 🙁 went into limp mode and also I am trying to figure out why my ax blower wont come on? I have new blower motor and bought 2 regulators all OEM equipment, yes expensive, 🙁 I was told to use OEM anything to do with Mercedes electrical parts 🙂 and I put in Freon everything comes on compressor but justwont blow and my scanner works on everyone elses car but my 2000 Mercedes Benz E320, I appreciate all the help,